Protege System Controller Reference Manual

Service Mode
The service mode determines how this service operates with the system controller. By default a service is set to
start with the operating system. Setting a service to "Start With The Operating System" (Start With O/S) allows
the service to operate automatically, if the system controller is reset or restarts the service will automatically
restart with the operating system. Manual control of the service can be set by using the Manual option for the
service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
Communications Port Number
The communications interface port defines which serial port the controller will use for communication with the
DVACS F1 and F2 subset units. Select the communication port that will be plugged in to the unit.
SV001 Port
Ext Port 1
Use the [1] and [3] keys to scroll the communication ports and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
Communications Port Speed
The communications port speed defines the baud rate at which the DVACS service will operate. The default
value for DVACS is 150 bits per second. If the speed or configuration is different adjust this setting to suit the
host configuration.
SV001 Speed
150
Use the [1] and [3] keys to scroll the communication port speed options and press [ENTER] to select the speed
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
Communications Port Parity
The communications port parity defines the parity configuration for the communication with the DVACS F1 and
F2 subset units. This will default to Even Parity however this can be adjusted to suit the host configuration.
SV001 Parity
Even Parity
Use the [1] and [3] keys to scroll the communication parity options and press [ENTER] to select the parity
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
176 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE