Protege System Controller Reference Manual

Test Report Time
The test report time in conjunction with option 2 sets the time of the day or the period that the test report
trouble zone activates. When option 2 is disabled the time programmed will be used as a period between
reports in hours and minutes.
Test report
time: 02:00
To modify the test report time (00:00 to --:--), use the keypad as explained in the section Entering Time and
Date Values (see page 342) and press [ENTER]. Setting a test report time of --:-- will disable the activation of a
test report.
Automatic Offline User Update Time
The automatic user offline update time in conjunction with option 1 in the miscellaneous options allows the panel
to update the users and other offline parameters on all intelligent modules at a set time of the day.
Offline update
time: 03:00
To modify the offline update time (00:00 to --:--), use the keypad as explained in the section Entering Time and
Date Values (see page 342) and press [ENTER]. Setting an offline update time of --:-- will disable the offline user
update function.
Modem Country Selection
The onboard modem must be configured for the region that the System Controller is being installed in to ensure
proper operation.
Modem Country
NZ/Aus
Use the [1] and [3] keys to scroll the modem country selection until reach the required country and press
[ENTER] to proceed. For more information about list control data entry refer to the section List Control Data
Entry (see page 344).
Default Panel Language
The System Controller supports multiple languages on the Keypad and the Serial Event Printers. The language
selected here will be the default language for users who have no language selected and also for any events.
Language
English
Use the [1] and [3] keys to scroll through the language selection until you reach the required language and
press [ENTER] to proceed. For more information about the list control data entry refer to the section List Control
Data Entry (see page 344).
System Controller Restart
To access the system controller restart menu select [MENU, 4, 9, 3]. The screen will immediately prompt
"Press [ENTER] to restart panel".
Pressing the [ENTER] key will restart the panel. The keypad that is currently being used will be restarted and will
go offline for a short period of time while the panel restarts. This is part of normal operation for a panel restart.
Press [ENTER] to
restart panel.
If a panel restart is not required press the [MENU] key to exit and remain logged in or press the [CLEAR] key to
exit and logout.
268 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE