Protege System Controller Reference Manual

Automation Name
If the selected automation entry has a name associated (some automation entries may not have a name
associated with them) the name programming screen will be shown.
AT001 Name
*Automation 001
To scroll automation entries by name use the [] and [] keys. To modify or enter a new name for the selected
automation item use the keypad as explained in section Entering Text and Names (see page 341) and press
[ENTER].
By default the automation name will be prefixed by an '*' this indicates that the name is an editable name in the
system.
Automation PGM
The automation entry will control the PGM or PGM group that is assigned to the control PGM option.
AT001 Control
pgm: --000:00
To modify the automation PGM or PGM Group, use the settings as explained in section Entering PGM and PGM
Groups (see page 345).
Automation PGM Activation Time
You can override the programmed activation time for a PGM or the group of PGM's by setting an activation
time.
AT001 PGM on
time: 00000 secs
To modify the PGM on time (00000 to 65535 Seconds), use the keypad as explained in section Entering
Decimal Numbers (see page 341) and press [ENTER].
Automation Clipsal C-Bus Application Number
The Clipsal C-Bus application number is used to link this automation point to a C-Bus Application that is
communicating with the system controller via a PRT-COMM and Serial Communications Interface. For example
if you want to link this automation point to activate when a Lighting, Switching and Load Control application
command is generated for a particular Group Address set the Application Type to 056 (056 or $38 Hex is the
Lighting, Switching and Load Control application, refer to the Clipsal C-Bus Application Specifications and
related documents.
AT001 C-Bus App
type: 000
To modify the C-Bus Application type enter a value (000 to 255), use the keypad as explained in section
Entering Decimal Numbers (see page 341) and press [ENTER].
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 259