Protege System Controller Reference Manual

Selecting a Zone Expander to Modify
Each zone expander is assigned a unique address from 001 to 250. Programming the address of the Zone
Expander Module (PRT-ZX16) is covered in the installation instructions included with your PRT-ZX16 Zone
Expander Module.
16 Zone Exp to
modify: ZX001
Type the appropriate 3-digit Zone Expander address or use the [] and [] keys. When the desired address
appears on the screen, press [ENTER] to program the selected Zone Expander module. The maximum number
of Zone Expanders that can be programmed is limited by your system's memory and configured profile.
Displaying Selected 16 Zone Expander Information
It is possible to show the current 16 Zone Expander registration and information details (registration, online and
version) from the 16 zone expander selection display.
16 Zone Exp to
modify: ZX001
Type the appropriate 3-digit 16 Zone Expander address or use the [] and [] keys. When the desired address
appears on the screen, press the [ARM] key to display information on the selected 16 Zone Expander. The
screen will now display information about the 16 Zone Expander that was selected. Press any other key to
return to the 16 Zone Expander selection window.
92-A8-90-C2 [9F]
V 1.04 1833 RO
The display above represents the following information for the selected keypad:
92-A8-90-C2
[9F]
V 1.04
Serial Number of the registered keypad at this address.
The current polling timeout value.
Software version of the registered keypad.
1833 Software build number.
R
O
The expander is registered
('*' will indicate no expander registered)
('*' will indicate the expander is offline)
To view the IP address of the module press the [] key from this view. If the module is connected over the
RS-485 LAN "---.---.---.---" will be displayed.
To list all offline or online modules refer to the Module Network Functions (see page 207).
Special functions are provided to update and update reset a module individually by using a shortcut key directly
from the keypad selection screen.
Key
[STAY]
[FORCE]
Function
Pressing the [STAY] key will update the zone expander number that is currently
displayed in the module selection window. This will program the module WITHOUT
resetting the module.
Pressing the [FORCE] key will update and init the zone expander number that is currently
displayed in the module selection window. This will program the module and then restart
the module.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 61