Protege System Controller Reference Manual

Operating Schedule
The operating schedule for the zone type determines when the zone type is valid. If the operating schedule is
not valid it will use the secondary zone type if it is programmed. A schedule is a series of times and days that
can be programmed to prevent the operating of functions based on a 7 day week and 24 hour clock. For more
information on the programming of the schedule refer to the Schedule Programming section (see page 279).
ZT001 Schedule
None
Use the [1] and [3] keys to scroll the schedule selection and press [ENTER] to select the schedule displayed.
For more information about the list control data entry refer to the section List Control Data Entry (see page 344).
Secondary Zone Type
A secondary zone type can be selected that will be used when the schedule of the zone type that is
programmed is not valid. The schedule of the secondary zone type must be valid or set to none.
ZT001 Secondary
None
Use the [1] and [3] keys to scroll the secondary zone type selection and press [ENTER] to select the zone type
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344). Programming a secondary zone type with the current zone type being edited will perform no
function.
Zone Type Keypad Group
A zone type keypad determines which keypads will be presented with alarm information when the zone that the
zone type is assigned generates an alarm.
ZT001 Key Grp
None
Use the [1] and [3] keys to scroll the available keypad groups and press [ENTER] to select the keypad group
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
Control Area
A zone type can be programmed to control the arming and disarming state of an area from a zone input (key
switch control). The area to be controlled by the zone type must be programmed with the force arming option.
Arming using a zone type is deemed to be a unattended arming condition and therefore the system will attempt
to arm the area in the force mode.
ZT001 Ctrl Area
None
Use the [1] and [3] keys to scroll the available area's and press [ENTER] to select the area displayed. For more
information about the list control data entry refer to the section List Control Data Entry (see page 344).
102 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE