Protege System Controller Reference Manual

Option 8 - Recycle Zone On Exit Delay
• Enabled the zone type will recheck the zones it is assigned when the area completes the exit delay cycle
and if a zone is open recycle the zone to force it in to generating an alarm.
Use this feature for a zone type used on a zone that may be breached during the exit delay such as a
window or door contact.
• Disabled the zone type operates normally.
Zone Type Miscellaneous Options
Miscellaneous options for the zone type configure options for various functions.
ZT001 Misc
[1-3-----]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 - Generate Siren Bell Output
• Enabled the zone type will activate the siren bell output programmed for the area.
• Disabled the zone type will not generate a bell output.
Option 2 - Restart Siren Bell Timer
• Enabled the zone type will restart the bell timer on each subsequent alarm.
• Disabled the zone type will not alter the bell timer if it is already active.
Option 3 - Save Alarm to Memory
• Enabled the zone type will save an alarm message to the area's alarm memory storage area.
• Disabled the zone type does not save an alarm message.
Option 4 - Disarm Control Area on Restore
• Enabled the zone type will disarm the control area when a zone assigned the zone type restores from an
alarm condition.
Use this feature and the arming control area feature as a on and off key switch arming input.
• Disabled the zone type takes no action on the control area.
Option 5 - Arm Control Area on Alarm
• Enabled the zone type will start arming the control area when a zone assigned the zone type generates an
alarm condition.
• Disabled the zone type takes no action on the control area.
Option 6 - Toggle Control Area State On Alarm
• Enabled the zone type will toggle the state of the control area when the zone that is assigned this zone type
generates an alarm.
• Disabled the zone type operates normally.
Option 7 - Force Arm Tamper
• Enabled the zone type will allow the zone to be force armed if the zone assigned the zone type is tampered.
• Disabled the zone type operates normally.
Option 8 - Activate Entry PGM For Bell Siren Time Duration
• Enabled the zone type will activate the entry PGM programmed for the area for the duration of the bell siren
time.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 105