Protege System Controller Reference Manual

Option 7 - 24HR Alarm
• Enabled the zone type will generate a 24HR alarm if the zone generates an alarm. The area state will not
affect the generation of this alarm.
• Disabled the zone type operates normally.
Option 8 - Fire Alarm
• Enabled the zone type will generate a fire alarm when it is activated. This zone type will also operate similar
to the 24HR Alarm option.
Most smoke detectors use a normally open contact so any zone that is assigned this option must have the
inverted state option selected and the EOL resistors option enabled.
• Disabled the zone type operates normally.
Zone Type Report Options
Reporting options for the zone type configure the operation of the zone type when reporting to a communication
service and includes options for various other zone type options.
ZT001 Report
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 - Report Alarm
• Enabled the zone type will generate a reportable alarm message.
• Disabled the zone type does not generate a reportable alarm message.
Option 2 - Report Tamper
• Enabled the zone type will generate a reportable tamper message.
• Disabled the zone type does not generate a reportable tamper message.
Option 3 - Report Bypass
• Enabled the zone type will generate a reportable bypass message.
• Disabled the zone type does not generate a reportable bypass message.
Option 4 - Report Restore
• Enabled the zone type will generate a reportable restore message.
• Disabled the zone type does not generate a reportable restore message.
Option 5 - Stay Zone
• Enabled the zone type will generate an alarm if the area is armed in stay mode. The zone will stay armed.
For zones that will be active when an area is armed in stay mode it is recommended to disable the event log
for the zone.
• Disabled the zone type operates normally.
Option 6 - Force Zone
• Enabled the zone type will allow the zones it is assigned to be force armed.
• Disabled the zone type operates normally.
Option 7 - No Exit Test
• Enabled the zone type will not verify the status of a zone prior to the area starting to arm. Use this feature to
assign zones in exit locations to prevent the area from generating a zone open warning when being armed.
• Disabled the zone type operates normally.
104 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE