Protege System Controller Reference Manual

Function Mode
The function mode determines how this function operates with the system controller. By default a function is set
to normal operation. Normal operation will mean the function is started if it was running when the system
restarts or is completely powered down (AC Failure and Battery Failure). The Run Once mode of operation will
allow the function to run once and then wait to be stopped and started by the user or operator.
FN001 Func Mode
Normal
Use the [1] and [3] keys to scroll the function mode until you reach the normal selection and press [ENTER] to
proceed to the next programmable option for the door control function. For more information about the list
control data entry refer to the section List Control Data Entry (see page 344).
Control Zone
The control zone's state will be set to be opened or closed according to the start of the Control PGM. If the
PGM is OFF the zone will be closed. If the PGM is ON, TIMED ON or PULSED ON the zone will be open.
The zone must be placed in an armed area to use it for control or reporting.
FN001 Control
Zone CP001:01
Halted
To modify the input Zone, use the settings as explained in section Entering Zones (see page 345).
Control PGM
The Control PGM's state will be followed by the Control Zone.
FN001 Control
pgm: CP001:01
Halted
To modify the Control PGM or PGM Group, use the settings as explained in section Entering PGM and PGM
Groups (see page 345).
Miscellaneous Options
These options are for the function.
FN001 Misc
[1--------]
Halted
Option 1 – Log Zone Events
• Enable Zone events when the zone changes state.
• Disable any Zone Events.
Option 2 - 8 – Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 249