Protege System Controller Reference Manual

Miscellaneous Options
The Miscellaneous options are used to select logging of service events.
SV001 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 - Log Acknowledge Events
• Enabled the service will log acknowledge communication events.
• Disabled the service will not log acknowledge communication events.
Option 2 - Log Poll Accept Events
• Enabled the service will log and event when the polling has been accepted by the remote host receiver.
• Disabled the service will not log polling messages.
Option 3 – Log Communications Retry
• Enabled the service will log a communications retry that occurs because of a network failure or loss of
service.
• Disabled the service will not log communications retries.
Option 4 – Log Communications Failure
• Enabled the service will log an event when communications have failed completely and the service is waiting
on another attempt.
• Disabled the service will not log the communications failure.
Option 5, 6, 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
i
When setting the log polling events and log acknowledgments the event buffer can be filled very
quickly. Use these options to check the connectivity of the service and then turn them off after
commissioning has been completed.
Area Group
An area group will define which areas this service will process when a reportable event is generated. An area
group of None (default) will result in all areas being sent with the service.
SV001 Area Grp
None
Use the [1] and [3] keys to scroll the area group selection and press [ENTER] to select the area group displayed.
For more information about the list control data entry refer to the section List Control Data Entry (see page 344).
198 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE