Protege System Controller Reference Manual

Area Control Function
To program the area control function ensure that the function you have selected is halted. Select the function
type selection screen as shown below for Area Control.
FN001 Func Type
Area Control
Use the [1] and [3] keys to scroll the function types until you reach the area control selection and press [ENTER]
to select the function type displayed and proceed to the next programmable option for the area control function.
For more information about the list control data entry refer to the section List Control Data Entry (see page 344).
Function Mode
The function mode determines how this function operates with the system controller. By default a function is set
to normal operation. Normal operation will mean the function is started if it was running when the system
restarts or is completely powered down (AC Failure and Battery Failure). The Run Once mode of operation will
allow the function to run once and then wait to be stopped and started by the user or operator.
FN001 Func Mode
Normal
Use the [1] and [3] keys to scroll the function mode until you reach the normal selection and press [ENTER] to
proceed to the next programmable option for the area control function. For more information about the list
control data entry refer to the section List Control Data Entry (see page 344).
Area Action
The action determines what action is performed on the area or area group that is programmed as a result of the
Input PGM. For key switch arming or simple arming of an area from a zone input use the area control options in
the zone type configuration. Refer to the Zone Type Programming (see page 100).
FN001 Action
None
Use the [1] and [3] keys to scroll the action types until you reach the required action that you want to be
performed and then press [ENTER] to proceed to the next programmable option for the area control function.
For more information about the list control data entry refer to the section List Control Data Entry (see page 344).
• Follow and Test
The area status follows the programmed input one state and will retest the input state continually.
Input One
ON
OFF
Area Control
ARM
DISARM
Test Action - If the output state is changed externally or is part of another programmable function the
programmable function will only restore the output state after 30 seconds has elapsed. This time is only
used if the programmable function was NOT responsible for the change in state.
• Not Follow and Test
Performs the same function as above however the area control function is inverted (NOT). This logic action
is a test action, consult the follow and test action for an explanation of the Test Function.
Input One
ON
OFF
Area Control
DISARM
ARM
• Pulse On
222 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE