20.01.2015 Views

Protege System Controller Reference Manual

Protege System Controller Reference Manual

Protege System Controller Reference Manual

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Entry Delay PGM Pulse OFF Time<br />

The entry delay PGM pulse off time is used to make the PGM output pulse on and off when activated. The value<br />

entered here must be greater than 0 and is in increments of 100ms. For example setting 10 will pulse the unit off<br />

for 1 second and then on for the programmed time set in the pulse on section.<br />

AR001 Entry<br />

time: 000 off<br />

To modify the pulse on time (000 to 255 100ms Increments), use the keypad as explained in section Entering<br />

Decimal Numbers (see page 341) and press [ENTER].<br />

Both the on and off pulse settings must have a value greater than 000 for this feature to operate.<br />

Exit Delay PGM or PGM Group<br />

You can assign an exit delay PGM or PGM group to activate whenever the area starts an exit delay cycle. The<br />

exit delay PGM or PGM Group will be deactivated when the area completes the arming cycle or if an alarm<br />

occurs during the exit delay period. Disarming the area will also result in the exit delay PGM or PGM group being<br />

deactivated.<br />

AR001 Exit<br />

pgm: --000:00<br />

To modify the Exit Delay PGM or PGM Group, use the settings as explained in section Entering PGM and PGM<br />

Groups (see page 345).<br />

Exit Delay PGM Pulse ON Time<br />

The exit delay PGM pulse on time is used to make the PGM output pulse on and off when activated. The value<br />

entered here must be greater than 0 and is in increments of 100ms. For example setting 10 will pulse the unit on<br />

for 1 second and then off for the programmed time set in the pulse off section.<br />

AR001 Exit<br />

time: 000 on<br />

To modify the pulse on time (000 to 255 100ms Increments), use the keypad as explained in section Entering<br />

Decimal Numbers (see page 341) and press [ENTER]. Both the on and off pulse settings must have a value<br />

greater than 000 for this feature to operate.<br />

Exit Delay PGM Pulse OFF Time<br />

The exit delay PGM pulse off time is used to make the PGM output pulse on and off when activated. The value<br />

entered here must be greater than 0 and is in increments of 100ms. For example setting 10 will pulse the unit off<br />

for 1 second and then on for the programmed time set in the pulse on section.<br />

AR001 Exit<br />

time: 000 off<br />

To modify the pulse on time (000 to 255 100ms Increments), use the keypad as explained in section Entering<br />

Decimal Numbers (see page 341) and press [ENTER]. Both the on and off pulse settings must have a value<br />

greater than 000 for this feature to operate.<br />

PRT-CTRL-SE <strong>Protege</strong> <strong>System</strong> <strong>Controller</strong> <strong>Reference</strong> <strong>Manual</strong> | PRT-CTRL-SE 119

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!