Protege System Controller Reference Manual

Exit Options
Exit options for the door type are currently all reserved and perform no function.
DT001 Exit
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1, 2, 3, 4, 5, 6, 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
Miscellaneous Options
Miscellaneous options for the door type are used to control the REX and REN operation of the door. Use these
settings to prevent the request to exit and request to enter from operating when an area is armed or when a
function is being processed.
DT001 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 – Disable REX Request To Exit
• Enabled the door will disable the REX (request to exit) operation.
• Disabled the door will allow REX (request to exit) operation.
Option 2 – Disable REN Request To Enter
• Enabled the door will disable the REN (request to enter) operation.
• Disabled the door will allow REN (request to enter) operation.
Option 3, 4, 5, 6, 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
Elevator
Each elevator is assigned a unique elevator address. Elevators are used for the control of access by users or to
monitor and control floors in a multi story high rise buildings.
Elevator to
modify: EL001
To access elevator programming, login using a valid code that has access to the elevator programming menu
and then select [MENU, 4, 5, 3]. The screen will then prompt you to "Select a Elevator to modify" requesting
that you enter a elevator number. Type the appropriate 3-digit elevator number or use the [] and [] keys to
scroll the available elevators. When the desired elevator number appears on the screen, press [ENTER] to
program the selected elevator. The maximum number of elevators that can be programmed is limited by your
system's memory and configured profile.
To browse the elevators by name press [ENTER] when prompted for a elevator number to modify and then use
the [] and [] keys to scroll the available elevators by their name.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 143