Protege System Controller Reference Manual

View
The view and control menu allows a keypad user to view the state of bypassed zones, alarm memory, current
trouble conditions, control doors, control automation points and control elevator floors. To access the view and
control functions, login using a valid code that is allowed view menu access and then select [MENU, 5]. Use the
up and down arrows to scroll the menu items or select the menu item directly using the short cut keys.
View and Control Menu
The view and control menu consists of 6 entries that can be scrolled to using the [] and [] arrow or selected
directly using the shortcut keys shown in the figure below.
Alarm Memory View
Alarm memory can be viewed by selecting [MENU, 5, 1] then using the [] and [] arrows to scroll the areas
that the current user can. If an area in the list has any alarm memory associated it will be shown on the second
line of the display. The [ENTER] key can be pressed to view the exact details of the alarm memory. Alarm
memory is provided for each area and stores the last four different activations.
• Select the alarm memory view menu [MENU, 5, 1]. The display will show the first area that the currently
logged in user has access to. This will display the alarm memory status on the second line of the display.
Warehouse
*Mem Empty*
• If an area does have an alarm in memory the display will show the alarm(s) in memory on the second line of
the display.
Warehouse
*Alarms in mem*
• Pressing the [ENTER] key will display the specific zone information for the area selected this will scroll the
zone information. In the following example the warehouse PIR was activated in the warehouse area.
Had ALARM on
Warehouse PIR
274 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE