Protege System Controller Reference Manual

Use the [1] and [3] keys to scroll the available profiles. When the desired profile is displayed on the screen, press
[ENTER] to load the selected profile. For more information about the list control data entry refer to the section
List Control Data Entry (see page 344). To view a profiles size and structures select [MENU, 4, 8, 3, 2].
When selecting a Profile a warning screen will be displayed informing the user that the option will reset the panel
and that they need to upload the information to be able to preserve the information from one profile to the next.
When the [ENTER] key is pressed a warning is immediately displayed to the user with a rejection tone beep, to
cancel press the [MENU] key or the [CLEAR] key to log out.
This will reset
all panel data !
Upload the panel
to backup data.
Press [ENTER] to
continue.
Press [MENU] or
[CLEAR] to exit.
To continue with the default you must press the [ENTER] key, this will reset the panel and setup the internal
memory structures to the selected profile.
Programmable Function Configuration
Programmable functions are used to perform special processing of actions when a particular event or operation
occurs. For example resetting users anti-passback status to the unknown state or controlling a group of doors.
To enter the programmable function menu login using a valid installer code and then select [MENU, 4, 8, 4].
The screen displays "Function to modify" as shown in the following example.
Function to
modify: FN001
Functions are a vital component to the Protege System and allow many variations of logic, process and
automation to be performed. Functions are small independent functions within the Protege that are used to
process information or perform specialized control functions.
When the functions appears on the screen, press [ENTER] to program the function. The maximum number of
functions that can be programmed is limited by your system's memory and configured profile.
i
Functions that attempt to perform circular referenced input and output (that is the use of a PGM
output to change the state of the same PGM output) will automatically be halted and a programming
error event will be generated.
Selecting a Function to Modify
Each function is assigned a unique function number from 001 to 250. Your system will be limited to specific
number of functions that are defined in the selected profile. For information on profiles refer to the section
Advanced Programming Section (see page 207).
Function to
modify: FN001
Type the appropriate 3-digit function number or use the [] and [] keys to scroll the available functions. When
the desired function appears on the screen, press [ENTER] to program and control the selected function.
216 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE