Protege System Controller Reference Manual

Option 4 - Bond Sense Input Enable
• Enabled the magnetic bond sense functions. The magnetic bond sense is a contact that indicates if the
magnetic bond between the electromagnet and the clamp is complete. It is used when a separate door
contact and bond sense input are to be used however the generation of door events should be processed
using both inputs.
When opening either of the two contacts open (Door Contact or Bond Sense Input) the door monitoring will
see this as the door being opened and process it accordingly.
• Disabled the reader will not include the bond sense input in the door status processing.
Option 5 - Request To Exit (REX) Enabled
• Enabled the reader expander will generate request to exit events from the REX input on the reader
expander.
• Disabled the keypad will not generate any REX events.
Option 6 - Request To Enter (REN) Enabled
• Enabled the reader expander will generate request to enter events from the REN input on the reader
expander.
• Disabled no action will be taken for the Request To Enter function.
Option 7 - Generate Format Error Events
• Enabled the reader expander will send a detailed format error to the system controller if it receives
information from the reader that does not comply with the programmed format. Format errors include bit
count, byte count, parity, checksum and LRC calculation failures.
• Disabled the reader will silently discard any format error. The format error will still be indicated on the reader
input data LED.
Option 8 - Intelligent Reader Tamper
• Enabled the reader expander will assume that the external device has smart messaging that allows a
communication path to be formed from the reading device (Card Reader) to the reader expander.
i
This allows the reader expander to monitor the reading device and generate a reader missing alarm
(Trouble Zone) if it fails to communicate with the reader expander, allowing the failure to be reported to
a monitoring station. For more information refer to the Nano Prox Programming Manual.
• Disabled the intelligent reader mode is disabled.
Reader Port 1 Miscellaneous Options
Options that relate to the miscellaneous reader functions.
RD001 R1 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 - Disarm Area
• Enabled the reader process will disarm the area designated by the reader type (ENTRY or EXIT) and the
door configuration programmed (If it has an area on the inside or outside assigned).
If this option is enabled and the reader is only used for area control then the area disarmed will be the area
assigned in the area control setting.
• Disabled the reader will not perform any disarm functions.
Option 2 - Allow User Access if Area Armed
• When the option is enabled the user will be granted access based on the access control configuration only
and the area status will not be checked against the user's ability to disarm the area.
74 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE