Protege System Controller Reference Manual

Control Area
The control area selects the area to control as a result of the action being performed by the programmable
function. To control an area group leave the control area option set to none and proceed to the Control Area
Group. Selecting both an area and an area group will result in only the area being controlled and the area group
being ignored. Programming an area and an area group will result in the area group not being used.
FN001 Area
None
Use the [1] and [3] keys to scroll the action types until you reach the required action that you want to be
performed and then press [ENTER] to proceed to the next programmable option for the area control function.
For more information about the list control data entry refer to the section List Control Data Entry (see page 344).
Control Area Group
The control area group selects the area group to control as a result of the action being performed by the
programmable function. To control an area leave the control area group section set to none and program an
area in the control area section. Programming an area and an area group will result in the area group not being
used.
FN001 Area Grp
None
Use the [1] and [3] keys to scroll the area groups until you reach the required group and then press [ENTER] to
proceed to the next programmable option for the area control function. For more information about the list
control data entry refer to the section List Control Data Entry (see page 344).
RTHP Control Function
The RTHP (Roof Top Heat Pump / Roof Top Heat Pack) programmable function allows the direct control of
multiple stage Roof Top Heat Pumps used for large retail or commercial space temperature control. There is a
substantial number of configuration screens for the RTHP unit and a working knowledge of Air Conditioning and
Temperature Set Point configuration is essential in setting up the correct operation of the programmable
function.
FN001 Func Type
RTHP Control
Use the [1] and [3] keys to scroll the function types until you reach the RTHP control selection and press
[ENTER] to select the function type displayed and proceed to the next programmable option for the RTHP
control function. For more information about the list control data entry refer to the section List Control Data
Entry (see page 344).
Function Mode
The function mode determines how this function operates with the system controller. By default a function is set
to normal operation. Normal operation will mean the function is started if it was running when the system
restarts or is completely powered down (AC Failure and Battery Failure). The Run Once mode of operation will
allow the function to run once and then wait to be stopped and started by the user or operator. Setting the run
once option for the RTHP will result in NO operation being performed and the function stopping a short time
after it is started.
FN001 Func Mode
Normal
Use the [1] and [3] keys to scroll the function mode until you reach the normal selection and press [ENTER] to
proceed to the next programmable option for the RTHP control function. For more information about the list
control data entry refer to the section List Control Data Entry (see page 344).
224 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE