Protege System Controller Reference Manual

Data Options
The data options are currently reserved and should not be modified from their default settings.
SV001 Data
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 – Service Used For Back Up Operation
• Enabled the service will NOT report messages and alarms unless it is started by another service that has
failed. It will then start reporting messages immediately from the point that the service that started it failed to
report and then return operation to the service that started. This cycle will continue until the service that
failed operates normally.
i
When using a service in Back Up mode the service should be programmed with the same area group
and account code as the service it is backing up. In some cases it may be desirable to program a
different account code for the back up service. Consult with your Monitoring Station Operator to
ensure you correctly configure the back up service.
• Disabled the dialer will operate as a normal service and report alarms as programmed.
Option 2, 3, 4, 5, 6, 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
Miscellaneous Options
The miscellaneous options allow you to program special functions and features for the contact ID service.
SV001 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 - Log Modem Service Events
• Enabled the service will provide step by step event information showing the call progression and detailed
logging information. This option can be turned on for diagnostic purposes but should not be enabled as
large volumes of events are stored.
• Disabled the dialer will not log events.
Option 2, 3, 4, 5, 6, 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
Area Group
An area group will define which areas this service will process when a reportable event is generated. An area
group of None (default) will result in all areas being sent with the service.
SV001 Area Grp
None
Use the [1] and [3] keys to scroll the area group selection and press [ENTER] to select the area group displayed.
For more information about the list control data entry refer to the section List Control Data Entry (see page 344).
158 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE