Protege System Controller Reference Manual

Communications Port Number
The communications interface port defines which serial port the controller will use for communication with the
Clipsal C-Bus PCI Interface. Select the communication port that will be plugged in to the PCI connection.
SV001 Port
Ext Port 1
Use the [1] and [3] keys to scroll the communication ports and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
Communications Port Speed
The communications port speed defines the baud rate at which the Clipsal C-Bus service will operate. The
default value for C-Bus is 9600 bits per second. If the speed or configuration is different adjust this setting to
suit the C-Bus PCI configuration.
SV001 Speed
9600
Use the [1] and [3] keys to scroll the communication port speed options and press [ENTER] to select the speed
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
Communications Port Parity
The communications port parity defines the parity configuration for the communication with the C-Bus PCI. This
will default to No Parity however this can be adjusted to suit the C-Bus PCI configuration.
SV001 Parity
No Parity
Use the [1] and [3] keys to scroll the communication parity options and press [ENTER] to select the parity
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
TCP/IP Primary IP Address
If the port option 'Ethernet' was selected then you are given the option to enter the IP address of the CNI unit.
SV005 Pri IP
191.012.003.077
To modify the IP address use the decimal entry from (000 to 255), use the keypad as explained in section
Entering Decimal Numbers (see page 341) and press [ENTER].
TCP/IP Primary Port
If the port option 'Ethernet' was selected then you are given the option to enter the TCP/IP Port of the CNI unit.
SV005 Primary
port: 09999
To modify the port number (00001 to 65534), use the keypad as explained in section Entering Decimal Numbers
(see page 341) and press [ENTER].
184 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE