Protege System Controller Reference Manual

Option 3 - Reserved
• Reserved do not modify
Option 4 - Switch To Second Phone Line On Failure
• Enabled the dialer will switch the secondary phone line over and use this to dial if the first phone line fails or
fails to communicate.
• Disabled the dialer will use the first phone line.
Option 5 - PABX Phone Number Requires Pause
• Enabled the dialer will insert a pause of 2.5 seconds after the PABX telephone number is dialed.
• Disabled the dialer will dial the PABX and phone number with a standard DTMF inter digit delay.
Option 6, 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
Events Options
The events options allow you to filter the type of events that this SIA service will send to the monitoring station.
SV001 Events
[123456--]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 - Report Opens
• Enabled the service will report opens (Disarming) for the areas that are part of the area group assigned. An
area group of none will mean ALL areas will be sent using this service.
• Disabled the dialer will not report opens.
Option 2 - Report Closes
• Enabled the service will report closes (Arming) for the areas that are part of the area group assigned. An
area group of none will mean ALL areas will be sent using this service.
• Disabled the dialer will not report closes.
Option 3 - Report Alarms
• Enabled the service will report alarms for the zones that are part of the area group assigned. An area group
of none will mean ALL areas will be sent using this service.
• Disabled the dialer will not report alarms.
Option 4 - Report Tampers
• Enabled the service will report tampers for the zones that are part of the area group assigned. An area
group of none will mean ALL areas will be sent using this service.
• Disabled the dialer will not report tampers.
Option 5 - Report Restore
• Enabled the service will report restores for the zones that are part of the area group assigned. An area
group of none will mean ALL areas will be sent using this service.
• Disabled the dialer will not report restores.
Option 6 - Report Bypass
• Enabled the service will report bypass's for the zones that are part of the area group assigned. An area
group of none will mean ALL areas will be sent using this service.
• Disabled the dialer will not report bypass's.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 171