Protege System Controller Reference Manual

Access Level Assignment
The access level determines what rights this user will have in the Protege system. For more information on the
programming of the access level refer to the Access Level Programming section (see page 40). Each user can
be assigned four different access levels, when a user requests a certain action the Protege system checks each
of the access levels in order until it finds one that has rights to perform the requested action. Each access level
can also be assigned an independent start and end time.
UN00001 Access
*Access Lvl 001
Use the [1] and [3] keys to scroll the access level selection and press [ENTER] to select the access level
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344) .
Access Level 1 Start Date
Setting the access level start date will disable the access level for this user until 00:00 on this date. If a start
time is also set the access level will be disabled until that time has past on this date.
UN00001 Axs1 Sta
date: --/--/----
Use the numerical keys to enter a valid date and then press [ENTER] to program the date. If you do not
program a time in the following section the access level will expire at midnight on the date that is programmed.
For more information about entering the date information refer to the section Date and Time Data Entry (see
page 342).
If you do not enter a valid date an error message will be shown, pressing the [STAY] key will allow you to clear
your entry or set the default value.
Access Level 1 Start Time
Setting the access level start time will disable the access level for the user until this time has past. If both the
start time and date are set then the access level will remain disabled until the date and time has past. If only
the time is set then the access level will be disabled until this time has past and will then remain enabled until
either the access level end time expires or until the midnight of that day.
Use this feature to program cards for temporary employees, trade people or contractors. This feature can also
be used for membership processing to prevent access once the membership period has expired.
UN00001 Axs1 Sta
time: --:--
Use the numerical keys to enter a valid time in a 24HR format and then press [ENTER] to program the time. If
you do not program a time in the following section the user will expire at midnight on the date that is
programmed. For more information about entering the date information refer to the section Date and Time Data
Entry (see page 342) .
If you do not enter a valid time an error message will be shown, pressing the [STAY] key will allow you to clear
your entry.
24 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE