Protege System Controller Reference Manual

Elevator Control
To program the Elevator Control function ensure that the function you have selected is halted. Select the
function type selection screen as shown below for Elevator Control.
FN001 Func Type
Elevator Ctrl
Use the [1] and [3] keys to scroll the function types until you reach the door control selection and press [ENTER]
to select the function type displayed and proceed to the next programmable option for the elevator control
function. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
Function Mode
The function mode determines how this function operates with the system controller. By default a function is set
to normal operation. Normal operation will mean the function is started if it was running when the system
restarts or is completely powered down (AC Failure and Battery Failure). The Run Once mode of operation will
allow the function to run once and then wait to be stopped and started by the user or operator.
FN001 Func Mode
Normal
Use the [1] and [3] keys to scroll the function mode until you reach the normal selection and press [ENTER] to
proceed to the next programmable option for the elevator control function. For more information about the list
control data entry refer to the section List Control Data Entry (see page 344).
Elevator Action
The action determines what action is performed on the elevator group that is programmed as a result of the
Input PGM. An action MUST be selected for the programmable function to operate correctly.
FN001 Action
None
Use the [1] and [3] keys to scroll the action types until you reach the required action that you want to be
performed and then press [ENTER] to proceed to the next programmable option for the elevator control
function. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
• Follow and Test
The floor group status follows the programmed input one state and will retest the input state every 30
second interval and change the floor group state accordingly.
Input One
ON
OFF
Floor Group
UNLOCKED
LOCKED
Test Action - If the floor group state is changed externally or is part of another programmable function the
programmable function will only restore the output state after 30 seconds has elapsed. This time is only
used if the programmable function was NOT responsible for the change in state. If a door has a door unlock
time and the door mode is set to timed this will unlock the door every 30 seconds.
• Not Follow and Test
Performs the same function as above however the output is inverted (NOT). This logic action is a test action,
consult the follow and test action for an explanation of the Test Function.
Input One
ON
OFF
Output
LOCKED
UNLOCKED
250 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE