Protege System Controller Reference Manual

User Programming
To access the user programming login using a valid master code and then select [MENU, 2, 1]. The screen
displays "Select user to modify" as shown in the following example.
Select user to
modify: UN00001
Every time you press the Enter key, the next screen appears. The different screens are described in the
following sub-sections. Programming the users in the Protege allow you to configure how user will interact with
the system and the options each user will have.
When programming a user that will require the loiter feature to be enabled the users expiry time will be reduced
to a date only and you will not be able to set a time for the user. The time is used to control the loiter time that
this user will be allocated in the loiter areas.
Selecting a User to Modify
Each user is assigned a unique user number from 00001 to 65535. When selecting a user to modify the user
number who logged in to the keypad will be shown.
Select user to
modify: UN00001
Type the appropriate 5-digit user number or use the [] and [] keys to scroll the available user numbers.
When the desired user number appears on the screen, press [ENTER] to program the selected user number.
The maximum number of users that can be programmed is limited by your system's memory and configured
profile.
User Names
If the selected user has a name associated (some users do not have a name associated with them) the name
programming screen will be shown.
UN00001 Name
Master
To scroll users by name use the [] and [] keys. To modify or enter a new name for the selected user use the
keypad as explained in section Entering Text and Names (see page 341) and press [ENTER].
By default the user name will be prefixed by an '*' this indicates that the name is an editable name in the
system. Some users do not have names, this is limited by the system memory and the profile configured.
User Access Code or PIN Number
The user code (PIN) can be from 1 to 8 digits in length. Entering a user code (PIN) that already exists in the
system results in the system generating an error and alerting the owner of that code. To modify or enter a new
pin number for the selected user follow the instructions in the section Entering PIN Numbers (see page 342) and
press [ENTER].
UN00001 Enter
code: 123456
For users to modify their own code or the code of another user with the same access level, the appropriate
code modification options must be turned refer to User Special Options (see page 29).
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 23