Protege System Controller Reference Manual

Zone Number Description Type Group
RDxxx:05 Lock Failure Power Fault General
RDxxx:06 Door 1 Forced Forced Door Access
RDxxx:07 Door 2 Forced Forced Door Access
RDxxx:08 Door 1 Left Open Left Open Access
RDxxx:09 Door 2 Left Open Left Open Access
RDxxx:10 Reader 1 Voltage Power Fault General
RDxxx:11 Reader 2 Voltage Power Fault General
RDxxx:12 Reader 1 Tamper System Tamper System
RDxxx:13 Reader 2 Tamper System Tamper System
RDxxx:14 Door 1 Lockout Attempts Access
RDxxx:15 Door 2 Lockout Attempts Access
RDxxx:16 Module Offline Module Offline System
In the above table a '*' indicates that the trouble zone will not generate a system trouble as by default it is not
assigned a trouble type or group. This can be done if required but is not recommended.
When using the reference table the reader expander address should be used in place of the 'xxx'.
Analog Expander
The following lists the trouble zones that operate on the Analog expander module. The Analog expander module
has 8 trouble zones.
Zone Number Description Type Group
AExxx:01 Module Tamper System Tamper System
AExxx:02 Analog Power Power Fault General
AExxx:03 Aux Power Power Fault General
AExxx:04 Reserved * *
AExxx:05 Reserved * *
AExxx:06 Reserved * *
AExxx:07 Reserved * *
AExxx:08 Module Offline Module Offline System
In the above table a '*' indicates that the trouble zone will not generate a system trouble as by default it is not
assigned a trouble type or group. This can be done if required but is not recommended.
When using the reference table the analog expander address should be used in place of the 'xxx'.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 325