Protege System Controller Reference Manual

Call Host Attempts
The call host attempts set the number of times the service will attempt to call the host PC Phone number before
giving up. This applies to all outgoing communication with a remote computer (Event Call and Call Back Security
On Login).
SV001 Call host
attempts: 008
To modify the call host attempts (000 to 255, a setting of 000 will result in the default of 008 seconds), use the
keypad as explained in section Entering Decimal Numbers (see page 341) and press [ENTER].
Rings To Answer
The rings to answer sets the number of rings the modem will wait before taking the line and generating carrier.
SV001 Rings to
answer: 008
To modify the rings to answer (000 to 255, a setting of 000 will result in the modem not answering the line), use
the keypad as explained in section Entering Decimal Numbers (see page 341) and press [ENTER].
PC Phone Number
The PC or remote phone number will be dialed by service when the Call Back Security Connection option is
enabled and a call back event is required or when the automatic event upload option is enabled. In both cases
the PC phone number is dialled sequentially for the maximum dialing attempts programmed in the service.
SV001 Phone 1
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select the phone number
displayed. To program a phone number select [MENU, 4, 7, 2]. For more information about the list control
data entry refer to the section List Control Data Entry (see page 344).
Protege SMGT Service
To program the Protege SMGT service ensure that the service that has been selected is halted. Press the
[ENTER] key until the display shows the service type selection screen. By default the Protege SMGT service is
programmed at SV001 and is running using the programmed TCP/IP address and port 10000.
SV001 Ser Type
Protege SMGT
Use the [1] and [3] keys to scroll the service types until you reach the Protege SMGT selection and press
[ENTER] to select the Protege direct service type displayed and proceed to the next programmable option for
the Protege direct service. For more information about the list control data entry refer to the section List Control
Data Entry (see page 344).
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 163