Protege System Controller Reference Manual

• Disabled the holiday will not belong to group 7.
Option 8 - Holiday Group Eight
• Enabled the holiday will belong to group 8.
• Disabled the holiday will not belong to group 8.
Daylight Saving Adjustment
To access daylight saving programming, login using a valid code that has access to the daylight saving
programming menu and then select [MENU, 6, 4]. The screen will then immediately display the daylight savings
start configuration screen.
D/S Starts on
None
Every time you press the Enter key, the next screen appears. The different screens are described in the
following sub-sections. Programming the daylight saving settings in the Protege System allows the system to
accurately compensate for daylight savings adjustments for the time zone the system controller is located in.
Daylight Savings Start Day
The start day selects the day of the month that daylight savings will start on. Daylight savings is programmed to
start on a day and end on a day for each time zone.
D/S Starts on
None
Use the [1] and [3] keys to scroll the starting day until you reach the required selection and press [ENTER] to
proceed to the next daylight savings screen. For more information about the list control data entry refer to the
section List Control Data Entry (see page 344).
Daylight Savings Start Month
The start month selects the month that daylight savings will start in.
D/S Start Month
None
Use the [1] and [3] keys to scroll the starting month until you reach the required selection and press [ENTER] to
proceed to the next daylight savings screen. For more information about the list control data entry refer to the
section List Control Data Entry (see page 344).
Daylight Savings End Day
The end day selects the day of the month that daylight savings will end on. Daylight savings is programmed to
start on a day and end on a day for each time zone.
D/S Ends on
None
Use the [1] and [3] keys to scroll the ending day until you reach the required selection and press [ENTER] to
proceed to the next daylight savings screen. For more information about the list control data entry refer to the
section List Control Data Entry (see page 344).
286 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE