Protege System Controller Reference Manual

Register Counter
• Protege System Management Suite
• A Programmable function that is programmed to deactivate the fire alarm control.
To program the register counter function ensure that the function you have selected is halted. Select the
function type selection screen as shown below for Register Counter.
FN001 Func Type
Reg Counter
Use the [1] and [3] keys to scroll the function types until you reach the door control selection and press [ENTER]
to select the function type displayed and proceed to the next programmable option for the door control function.
For more information about the list control data entry refer to the section List Control Data Entry (see page 344).
Function Mode
The function mode determines how this function operates with the system controller. By default a function is set
to normal operation. Normal operation will mean the function is started if it was running when the system
restarts or is completely powered down (AC Failure and Battery Failure). The Run Once mode of operation will
allow the function to run once and then wait to be stopped and started by the user or operator.
FN001 Func Mode
Normal
Use the [1] and [3] keys to scroll the function mode until you reach the normal selection and press [ENTER] to
proceed to the next programmable option for the door control function. For more information about the list
control data entry refer to the section List Control Data Entry (see page 344).
Miscellaneous Options
These options are for the function.
FN001 Misc
[1--------]
Halted
Option 1 – Increment on Zone Open
• Enable the counter will increment when the zone opens (alarm).
• Disable.
Option 2 – Increment on Zone Close
• Enable the counter will increment when the zone closes (seal).
• Disable.
Option 3 – Log Counter Events
• Enable the function will log an event for every increment.
• Disable.
Option 4 – Decrement on Zone Open
• Enable the counter will decrement when the zone opens (alarm).
• Disable.
Option 5 – Decrement on Zone Close
• Enable the counter will decrement when the zone closes (seal).
• Disable.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 253