Protege System Controller Reference Manual

Option 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
Data Options
The data options are currently reserved and should not be modified from their default settings.
SV001 Data
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1, 2, 3, 4, 5, 6, 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
Miscellaneous Options
The miscellaneous options allow you to program special functions and features for the SIA reporting format.
SV001 Misc
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 - Log Modem Service Events
• Enabled the service will provide step by step event information showing the call progression and detailed
logging information. This option can be turned on for diagnostic purposes but should not be enabled as
large volumes of events will be generated.
• Disabled the dialer will not log call progression events.
Option 2 - 4 Digit Point Reporting Codes
• Enabled the SIA service will use a 4 digit reporting code for the client, the SIA standard supports 6 digits
however some receivers do not comply with the full SIA specification or the automation software connected
limits the acceptance of large point numbers. Verify the configuration of the receiver with the monitoring
company prior to setting these options.
i
If a 4 Digit Account is to be used program the last 4 digits of the account code with the account ID.
For example if you are reporting to account code 9712 program the SIA account code as 009712.
• Disabled the SIA service will send 6 digit point codes.
Option 3 - Pad Area Account Code To 6 Digits
• Enabled the SIA service will pad the upper 2 digits of the 6 digit account code with 00 when sending the
client code of an area in place of the service configured account code when multiple account codes are
being used. The client code when programmed in an area can only be 4 digits refer to the Area
Programming Section (see page 112).
If option 2 is enabled then the SIA service will report all account codes as 4 digits regardless.
i
• Disabled the SIA service will send 4 digit area account codes.
172 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE