Protege System Controller Reference Manual

Option 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
Data Options
The data options are used to log information that is received, make the DVACS service respond to an all call
code or respond to odd/even all call requests.
SV001 Data
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 - Log Communication Events
• Enabled the service will log communication events that occur. Please be aware that when used with a
polling service such as DVAC's will fill the event buffer with a significant amount of data and should only be
used for testing and configuration purposes.
• Disabled the service will not log communication events.
Option 2 - Log DVAC Messages
• Enabled the service will log messages that are sent from the DVAC's network and store these in the event
log. Once again this will result in a large number of events being saved.
• Disabled the service will not log DVAC messages.
Option 3 - Respond All Call Command A
• Enabled the service will send an event if it has one ready when the DVAC's host requests an All Call A
command.
• Disabled the service will not respond to an All Call Command A.
Option 4 - Respond All Call Command B
• Enabled the service will send an event if it has one ready when the DVAC's host requests an All Call B
command.
• Disabled the service will not respond to an All Call Command B.
Option 5 - Respond All Call Odd/Even Address
• Enabled the service will send an event if it has one ready when the DVAC's host requests an All Call A
command and the device address is an Odd Address or if the requests an All Call B command and the
device address is an Even Address.
• Disabled the service will not respond to an Odd/Even All Call Command.
Option 6, 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
i
When setting the all call options in the data configuration for DVAC only enable one of the available
options. Setting more than one of the all call options will result in the first option that is set being used.
178 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE