Protege System Controller Reference Manual

Ripple Off Time
The ripple off time determines the time that each PGM output will be delayed before being deactivated when the
ripple control function is stepping the PGM outputs down.
FN001 Ripple off
time: 00000 secs
To modify the ripple off time (00000 to 65535 seconds), use the keypad as explained in section Entering
Decimal Numbers (see page 341) and press [ENTER].
Stage 1 PGM
The first PGM in the 8 PGM outputs that can be programmed for the ripple control function.
FN001 Stage 1
pgm: --000:00
To modify the Stage 1 PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
345).
Stage 2 PGM
The second PGM in the 8 PGM outputs that can be programmed for the ripple control function.
FN001 Stage 2
pgm: --000:00
To modify the Stage 2 PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
345).
Stage 3 PGM
The third PGM in the 8 PGM outputs that can be programmed for the ripple control function.
FN001 Stage 3
pgm: --000:00
To modify the Stage 3 PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
345).
Stage 4 PGM
The fourth PGM in the 8 PGM outputs that can be programmed for the ripple control function.
FN001 Stage 4
pgm: --000:00
To modify the Stage 4 PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
345).
Stage 5 PGM
The fifth PGM in the 8 PGM outputs that can be programmed for the ripple control function.
FN001 Stage 5
pgm: --000:00
To modify the Stage 5 PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
345).
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 241