Protege System Controller Reference Manual

Keypad Offline Menu Options
These options turn on or off the menus that are available when the keypad is logged out or offline. The keypad is
logged out or offline when no valid user code (PIN) has been entered. It is important to note that even if a menu
cannot be accessed online through this keypad (see menu groups); it is possible that it could still be accessed
through the offline menu if the following options are turned on. In the same instance a user can be able to
access a menu online but not offline.
KP001 Offline
[-2-4----]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 - Automation Menu
• Enabled the keypad will allow access to the Automation Menu if no user is logged in and a user press's the
[MENU] key.
• Disabled the keypad will not allow access to the Automation Menu offline.
Option 2 - View Trouble Menu
• Enabled the keypad will allow access to the View Trouble Menu if no user is logged in and a user press's
the [MENU] key.
• Disabled the keypad will not allow access to the View Trouble Menu offline.
Option 3 - Event Review Menu
• Enabled the keypad will allow access to the Event Review Menu if no user is logged in and a user press's
the [MENU] key.
• Disabled the keypad will not allow access to the Event Review Menu offline.
Option 4 - Keypad Information Menu
• Enabled the keypad will allow access to the Keypad Information Menu if no user is logged in and a user
press's the [MENU] key. It is recommended to leave this option enabled.
• Disabled the keypad will not allow access to the Keypad Information Menu offline.
Option 5, 6, 7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
Zone Expander
To access the Zone Expander module programming login using a valid installer code and then select [MENU, 4,
1, 2]. The screen displays "Zone exp to modify" as shown in the following example.
16 Zone Exp to
modify: ZX001
Every time you press the Enter key, the next screen appears. The different screens are described in the
following sub-sections. Programming the Zone Expander allows you to set the polling time of the module and
power supply options.
When programming modules some options are processed at the module, for these options to operate correctly
a network update must be performed and the zone expander must be registered and online.
Updating modules can be accessed by selecting [MENU, 4, 8, 1, 3], you can also check the status of your
modules by selecting [MENU, 4, 8, 1, 1] for all modules presently offline and [MENU, 4, 8, 1, 2] for all online
modules. For more information refer to the Advanced menu section (see page 207).
60 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE