Protege System Controller Reference Manual

Access Control
To access the access programming menu, login using a valid code that has access to the access programming
menu and then select [MENU, 5]. The Access menu enables you to set up and program all the doors in your
system. This includes setting areas outside and inside the door as well as special options for each door.
To allow certain users access to a door the users access level must have a door group assigned. To create or
modify door groups refer to the door group programming section. Doors can also be interlocked preventing
other users from gaining access to the door if another door is open or not locked.
Door
Each door is assigned a unique door address. Doors are used for the control of access by users or to monitor
and control doors to allow the flow of people in to an area.
Select door to
modify: DR001
To access door programming, login using a valid code that has access to the door programming menu and
then select [MENU, 5, 1]. The screen will then prompt you to "Select a door to modify" requesting that you
enter a door number. Type the appropriate 3-digit door number or use the [] and [] keys to scroll the
available doors. When the desired door number appears on the screen, press [ENTER] to program the selected
door. The maximum number of doors that can be programmed is limited by your system's memory and
configured profile.
To browse the doors by name press [ENTER] when prompted for a door number to modify and then use the
[] and [] keys to scroll the available doors by their name.
Selecting a Door to Modify
Each door is assigned a unique door number from 001 to 250. Your system will be limited to specific number of
doors that are defined in the selected profile. For information on profiles refer to the Advanced Programming
Section (see page 207).
Select door to
modify: DR001
Type the appropriate 3-digit door number or use the [] and [] keys to scroll the available door numbers.
When the desired door number appears on the screen, press [ENTER] to program the selected door number.
The maximum number of doors that can be programmed is limited by your system's memory and configured
profile.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 131