Protege System Controller Reference Manual

Handshake Time
The handshake time determines the time it takes for the remote receiving unit to answer and provide a
handshake message for the contact ID format. By default this is set to 030 seconds and should only be adjust if
a longer than normal call completion is required.
SV001 Handshake
time: 030
To modify the handshake time (000 to 255, a setting below 010 will result in the default of 30 seconds being
programmed), use the keypad as explained in section Entering Decimal Numbers (see page 341) and press
[ENTER].
Redial Time
The redial time determines inter phone number dialing timeout. A value of 20 seconds is programmed by default
meaning each phone number will be dialled with 20 second intervals from the time the previous call was
terminated.
SV001 Redial
time: 020
To modify the redial time (000 to 255, a setting below 010 will result in the default value of 030 being
programmed), use the keypad as explained in section Entering Decimal Numbers (see page 341) and press
[ENTER].
Off Hook PGM
The off hook PGM is activated when the service takes the telephone line and is deactivated when the service
completes communication. This PGM setting can be used with remote exchange systems that require ground
start communication connections.
SV001 Off Hook
pgm: --000:00
To modify the off hook PGM, use the settings as explained in section Entering PGM and PGM Groups (see page
345).
Report OK PGM
The report ok PGM is activated when the service completes the reporting and the messages have been
successfully acknowledge. The PGM is activated when the service returns a reporting complete result OK
message. The PGM is not deactivated and should be programmed with a timer, this can be connected to an
external audible device to signal that the report was completed. Using this feature with the shorten exit delay for
an area allows an end user to verify the communication path on arming of the building
SV001 Report Ok
pgm: --000:00
To modify the report ok PGM, use the settings as explained in section Entering PGM and PGM Groups (see
page 345).
160 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE