Protege System Controller Reference Manual

Area Squawk Options
The squawk options determine if the Bell PGM is activated with one short squawk when the system is armed
and two short squawks when the system is disarmed.
AR001 Special
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 – Bell Squawk Arm Start
• Enabled the area will squawk the Bell PGM when the arming process starts.
• Disabled the area will not squawk.
Option 2 – Bell Squawk Arm Complete
• Enabled the area will squawk the Bell PGM when the arming process is complete and the exit delay has
ended.
• Disabled the area will not squawk.
Option 3 – Bell Squawk Arm Unattended
• Enabled the area will only squawk the Bell PGM when the area is armed by an unattended arming, e.g.
Card Reader, Remote Service, Key Switch, Door, another Area etc.
• Disabled the area will not squawk.
Option 4 – Bell Squawk Disarm
• Enabled the area will squawk the Bell PGM when the area is disarmed.
• Disabled the area will not squawk.
Option 5 – Bell Squawk Report OK
• Enabled the area will squawk the Bell PGM when the a successful Area Armed report has been sent and
acknowledge by a reporting service.
• Disabled the area will not squawk.
Options 6,7 and 8 - Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
130 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE