Protege System Controller Reference Manual

Space Humidity Register
The space humidity register is the register that is updated by an analogue module input channel connected to a
humidity sensor. The space humidity sensor is typically located within the space the RTHP is controlling at a
height of 1.5 to 2.5 meters above floor level.
FN001 Space rh
reg: 00000
To modify the space humidity register (00000 to 65535, use the keypad as explained in section Entering
Decimal Numbers (see page 341) and press [ENTER].
External Fresh Air Temperature Register
The external fresh air temperature register is the register that is updated by an analogue module input channel
connected to a temperature sensor. The external fresh air temperature is typically from a sensor located within
fresh air intake of the RTHP in the cowling section. The fresh air temperature sensor is used to calculate the
ability to cool the space with direct fresh air and is calculated prior to a demand for cooling.
FN001 Fresh temp
reg: 00000
To modify the fresh temperature register (00000 to 65535, use the keypad as explained in section Entering
Decimal Numbers (see page 341) and press [ENTER].
Economiser Damper Register
The Base data register is used as the first register in the list of registers used to configure, program and control
the RTHP. The only registers that are not included in the base registers are ones that must link to an analog
input or analog output for external sensors (Temp, Humidity or Dampers). A base data register setting MUST be
set.
FN001 Space rh
reg: 00000
To modify the base data register (00000 to 65535, use the keypad as explained in section Entering Decimal
Numbers (see page 341) and press [ENTER].
Floor Tempering Control Function
The Floor Tempering programmable function allows the direct control of a single stage floor tempering system
that controls a duct mounted heater and/or cooling compressor. The support for one heating and one cooling
state is provided as well as a forward and reverse operation.
FN001 Func Type
Floor Temping
Use the [1] and [3] keys to scroll the function types until you reach the Floor Temping selection and press
[ENTER] to select the function type displayed and proceed to the next programmable option for the Floor
Temping control function. For more information about the list control data entry refer to the section List Control
Data Entry (see page 344).
232 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE