NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Control keypad 101(110)
7
READY
I/Oterm
Standard
D1D3
READY
I/Oterm
Version
2.01
S6.8.4
READY
I/Oterm
Applications
A1 A7
Figure 7-25. Applications info page
A6.8.4.1
Basic
READY
I/Oterm
D1 D3
READY
I/Oterm
Application id
NXFIFF01
In the Applications information page, push the Menu button right to enter the Application pages of
which there are as many as there are applications loaded into the frequency drive. Locate the
application you want information about with the Browser buttons and then enter the Information
pages with the Menu button right. Use again the Browser buttons to see the different pages
Hardware (S6.8.5)
The Hardware information page provides information on the following hardware-related topics:
Page
Content
6.8.5.1 Nominal power of the unit
6.8.5.2 Nominal voltage of the unit
6.8.5.3 Brake chopper
6.8.5.4 Brake resistor
Table 7-11. Hardware information pages
Expander boards (S6.8.6)
Information about the basic and option boards connected to the control board can be found in the
Expanders submenu (see Chapter 6.2).
You can check the status of each slot by entering the board submenu with the right arrow menu
button and using the Browser buttons to choose the board whose status you wish to check. Push
the right arrow menu button again to display the status of the board. The keypad will also display
the program version of the respective board when either one of the Browser buttons is pushed.
If no board is connected to the slot the text 'no board' will be shown. If a board is connected to a
slot but the connection is somehow lost the text 'no conn.' is displayed. See Chapter 6.2 for more
information.
For more information on the expander board-related parameters, see Chapter 7.3.7.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com