NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

142 Description of Parameters Honeywell
12 DC braking command
Contact closed: In Stop mode, the DC braking operates until the contact is opened.
See Figure 8-17.
13 Motor potentiometer UP
Contact closed: Reference increases until the contact is opened.
Output
frequency
Output
frequency
ID515
t
t
DIN2
RUN
STOP
DIN2
RUN
STOP
NX12K32
Figure 8-17. DC braking command (selection 12) selected for DIN2.
Left: Stop mode = Ramp; Right: Stop mode = Coasting
320 AI1 signal range 34567 (2.2.4, 2.2.16, 2.2.2.3)
Applic. 3,4,5 6 7
Sel.
0 0…100% 0…100% 0…100%
1 20…100% 20…100% 20…100%
2 Customised –10…+10V Customised
3 Customised
Table 8-9. Selections for parameter ID320
For selection 'Customised', see parameters ID321 and ID322.
321 AI1 custom setting minimum 34567 (2.2.5, 2.2.17, 2.2.2.4)
322 AI1 custom setting maximum 34567 (2.2.6, 2.2.18, 2.2.2.5)
These parameters set the analogue input signal for any input signal span within -160—
160%.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com