NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

66 Multi-purpose Control Application Honeywell
6.4.2 Defining a terminal for a certain function with NCDrive programming tool
If you use the NCDrive Programming Tool for parametrizing you will have to establish the connection
between the function and input/output in the same way as with the control panel. Just pick
the address code from the drop-down menu in the Value column (see the Figure below).
Figure 6-2. Screenshot of NCDrive programming tool; Entering the address code
!
WARNING
Be ABSOLUTELY sure not to connect two functions to one and
same output in order to avoid function overruns and to ensure
flawless operation.
Note: The inputs, unlike the outputs, cannot be changed in RUN state.
6.4.3 Defining unused inputs/outputs
All unused inputs and outputs must be given the board slot value 0 and the value 1 also for the terminal
number. The value 0.1 is also the default value for most of the functions. However, if you want
to use the values of a digital input signal for e.g. testing purposes only, you can set the board slot
value to 0 and the terminal number to any number between 2…10 to place the input to a TRUE
state. In other words, the value 1 corresponds to 'open contact' and values 2 to 10 to 'closed
contact'.
In case of analogue inputs, giving the value 1 for the terminal number corresponds to 0% signal
level, value 2 corresponds to 20%, value 3 to 30% and so on. Giving value 10 for the terminal
number corresponds to 100% signal level.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com