NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Control keypad 93(110)
7
READY
READY
I/Oterm
I/Oterm
S6.4 S6.4.1
ParamComparison
C1C3
OR
Set1
S6.4.1
Set1
0
READY
I/Oterm
P1P6
READY
I/Oterm
P2.1.2= 50.0
20.0 Hz
READY
I/Oterm
P2.1.2= 50.0
20.0 Hz
enter
EDIT VALUE
CONFIRM CHANGE
Figure 7-13. Parameter comparison
7.3.6.5 Security
NOTE: The Security submenu is protected with a password. Store the password in a safe place!
Password (S6.5.1)
The application selection can be protected against unauthorised changes with the Password
function (S6.5.1).
By default, the password function is not in use. To activate the function, enter the edit mode by
pushing the right arrow menu button. A blinking zero appears in the display and a password can
be set with the Browser buttons. The password can be any number between 1 and 65535.
Note The password can be set by digits. In the edit mode, push the right arrow menu button once
again and another zero appears on the display. First set the units. Push the left arrow menu
button and set the tens etc. Finally, confirm the password setting with the Enter button. After this,
wait until the Timeout time (P6.6.3) (see page 96) has expired before the password function is
activated.
If the applications or the password itself are changed the system will request the current
password. The password will be entered with the Browser buttons.
READY
READY
I/Oterm
I/Oterm
enter
I/Oterm
S6.5.1 S6.5.1 S6.5.1
Password
Not in use
Password
0
OR:
Password
00
READY
enter
Figure 7-14. Password setting
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com