NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Control keypad 85(110)
7
7.3.5 Fault history menu (M5)
The Fault history menu can be entered from the Main menu by pushing the right arrow menu
button menubuttonright when the location indication M5 is visible on the first line of the keypad
display.
All faults are stored in the Fault history menu, Browse through them using the Browser buttons.
Additionally, the Fault time data record pages (see Chapter 7.3.4.3) are accessible at each fault.
Return to the previous menu anytime by pushing the Menu button left.
The memory of the frequency drive can store a maximum of 30 faults in the order of appearance.
The number of faults currently in the fault history is shown on the value line of the main page
(H1H#). The order of the faults is indicated by the location indication in the upper left corner of
the display. The latest fault carries the indication F5.1, the second latest F5.2 etc. If there are 30
uncleared faults in the memory the next occurring fault will erase the oldest from the memory.
Pressing the Enter button for about 2 to 3 seconds resets the whole fault history. Then, the symbol
H# will change to 0.
READY
I/Oterm
5 ChargeSwitch
I/Oter m
Operation hours
READY
I/Oterm
Fault history
H1H3
READY
I/Oterm
11 Output phase
T1T7
I/Oterm
Operation days
17
PUSH
enter
to reset
Figure 7-8. Fault history menu
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com