23.01.2015 Views

NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

7<br />

84(110) Control keypad<br />

50 Analog input I in < Current at the analogue input is < 4mA. Check the current loop circuitry.<br />

4mA (selected − control cable is broken or loose<br />

signal range 4 to<br />

20 mA)<br />

− signal source has failed<br />

51 External fault Digital input fault.<br />

52 Keypad communication<br />

fault<br />

The connection between the control keypad<br />

and the freq. drive is broken.<br />

Check keypad connection and possible<br />

keypad cable.<br />

53 Fieldbus fault The data connection between the fieldbus<br />

Master and the fieldbus board is broken.<br />

Check installation.<br />

If installation is correct contact your<br />

nearest distributor.<br />

54 Slot fault Defective option board or slot Check board and slot.<br />

Contact your nearest distributor.<br />

56 PT100 board<br />

temp. fault<br />

Temperature limit values set for the<br />

PT100 board parameters have been<br />

exceeded<br />

Find the cause of temperature rise<br />

Table 7-4. Fault codes<br />

7.3.4.3 Fault time data record<br />

When a fault occurs the information described above in 7.3.4 is displayed. By pushing the right<br />

arrow menu button it is possible to view the Fault time data record menu indicated by T.1T.13.<br />

In this menu, some selected important data valid at the time of the fault are recorded. This feature<br />

is intended to help the user or the service person to determine the cause of fault.<br />

The data available are:<br />

T.1<br />

Counted operation days<br />

d<br />

(Fault 43: Additional code)<br />

T.2<br />

Counted operation hours<br />

hh:mm:ss<br />

(Fault 43: Counted operation days) (d)<br />

T.3<br />

Output frequency<br />

Hz<br />

(Fault 43: Counted operation hours) (hh:mm:ss)<br />

T.4 Motor current A<br />

T.5 Motor voltage V<br />

T.6 Motor power %<br />

T.7 Motor torque %<br />

T.8 DC voltage V<br />

T.9 Unit temperature °F<br />

T.10 Run status<br />

T.11 Direction<br />

T.12 Warnings<br />

T.13 0-speed<br />

Table 7-5. Fault time recorded data<br />

Real time record<br />

If real time is set to run on the frequency drive the data items T1 and T2 will appear as follows:<br />

T.1 Counted operation days yyyy-mm-dd<br />

T.2 Counted operation hours hh:mm:ss,sss<br />

Automation and Control Solutions<br />

Honeywell<br />

Honeywell Limited-Honeywell Limitée<br />

1985 Douglas Drive North 35 Dynamic Drive<br />

Golden Valley, MIN 55422 Scarborough, Ontario <strong>63</strong>-<strong>2600</strong>-1<br />

MIV 4Z9<br />

www.honeywell.com

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!