NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Control keypad 91(110)
7
READY
I/Oterm
S6.3.1
Parameter sets
Select
READY
I/Oterm
S6.3.1
Parameter sets
LoadFactDef
enter
CONFIRM
CANCEL
READY
I/Oterm
S6.3.1
Parameter sets
Wait...
OK
READY
I/Oterm
S6.3.1
Parameter sets
Figure 7-11. Storing and loading of parameter sets
Upload parameters to keypad (To keypad, S6.3.2)
This function uploads all existing parameter groups to the keypad provided that the drive is
stopped.
Enter the To keypad page (S6.3.2) from the Parameter copy menu. Push the right arrow menu
button to enter the edit mode. Use the Browser buttons to select the option All parameters and
press the Enter button. Wait until 'OK' appears on the display.
READY
READY
READY
I/Oterm
I/Oterm
I/Oterm
S6.3 S6.3.2 S6.3.2
Copy Parameters Up to keypad Up to keypad
P1P4
Select
All param.
enter
CONFIRM
CHANGE VALUE
CANCEL
READY
I/Oterm
S6.3.2
Up to keypad
Wait...
READY
I/Oterm
S6.3.2
Up to keypad
OK
Figure 7-12. Parameter copy to keypad
Download parameters to drive (From keypad, S6.3.3)
This function downloads one or all parameter groups uploaded to the keypad to a drive provided
that the drive is in STOP status.
Enter the From keypad page (S6.3.3) from the Parameter copy menu. Push the right arrow menu
button to enter the edit mode. Use the Browser buttons to select either the option All parameters
or Application parameters and press the Enter button. Wait until 'OK' appears on the display.
The procedure to download the parameters from keypad to drive is similar to that of from drive to
keypad. See above.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com