NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

78 Multi-purpose Control Application Honeywell
6.6.5 Output signals
6.6.5.1 Delayed digital output 1 (Keypad: Menu M2 G2.3.1)
Code Parameter Min Max Unit Default Cust ID Note
P2.3.1.1
Digital output 1
Possible to invert with
0 0.1 486
signal selection
ID1084 (NXP only)
0=Not used
1=Ready
2=Run
3=Fault
4=Fault inverted
5=FC overheat warning
6=Ext. fault or warning
7=Ref. fault or warning
8=Warning
9=Reverse
10=Jogging spd selected
11=At speed
12=Mot. regulator active
P2.3.1.2
Digital output 1
13=Freq. limit 1 superv.
0 26 1 312
function
14=Freq. limit 2 superv.
15=Torque limit superv.
16=Ref. limit supervision
17=External brake control
18=I/O control place act.
19=FC temp. limit superv.
20=Reference inverted
21=Ext. brake control
inverted
22=Therm. fault or warn.
23=AI supervision
24=Fieldbus input data 1
25=Fieldbus input data 2
26=Fieldbus input data 3
P2.3.1.3
Digital output 1 on
delay
0,00 320,00 s 0,00 487 0,00 = delay not in use
P2.3.1.4
Digital output 1 off
delay
0,00 320,00 s 0.00 488 0,00 = delay not in use
Table 6-13. Delayed digital output 1 parameters, G2.3.1
6.6.5.2 Delayed digital output 2 (Keypad: Menu M2 G2.3.2)
Code Parameter Min Max Unit Default Cust ID Note
P2.3.2.1
Digital output 2
Possible to invert with
0 0.1 489
signal selection
ID1084 (NXP only)
P2.3.2.2
Digital output 2
function
0 26 0 490 See par. 2.3.1.2
P2.3.2.3
Digital output 2 on
delay
0,00 320,00 s 0,00 491 0,00 = delay not in use
P2.3.2.4
Digital output 2 off
delay
0,00 320,00 s 0,00 492 0,00 = delay not in use
Table 6-14. Delayed digital output 2 parameters, G2.3.2
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com