NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Honeywell Multi-step Speed Application 35
4. MULTI-STEP SPEED CONTROL APPLICATION
(Software ASFIFF04)
4.1 Introduction
Select the Multi-step Speed Control Application in menu M6 on page S6.2.
The Multi-step Speed Control Application can be used in applications where fixed speeds are
needed. Totally 15 + 2 different speeds can be programmed: one basic speed, 15 multi-step speeds
and one jogging speed. The speed steps are selected with digital signals DIN3, DIN4, DIN5 and
DIN6. If jogging speed is used, DIN3 can be programmed from fault reset to jogging speed select.
The basic speed reference can be either voltage or current signal via analogue input terminals (2/3
or 4/5). The other one of the analogue inputs can be programmed for other purposes.
• All outputs are freely programmable.
Additional functions:
• Programmable Start/Stop and Reverse signal logic
• Reference scaling
• One frequency limit supervision
• Second ramps and S-shape ramp programming
• Programmable start and stop functions
• DC-brake at stop
• One prohibit frequency area
• Programmable U/f curve and switching frequency
• Autorestart
• Motor thermal and stall protection: Programmable action; off, warning, fault
The parameters of the Multi-Step Speed Control Application are explained in Chapter 8 of this
manual. The explanations are arranged according to the individual ID number of the parameter.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com