NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Cabling and connections 49(110)
Connect the cables:
4
• Strip the motor and mains cables as advised in Figure 6-6 and
Table 6-6.
• Remove the screws of the cable protection plate. Do not open the
cover of the power unit!
• Make holes into and pass the cables through the rubber
grommets on the bottom of the power unit (see e.g. ).
• Connect the mains, motor and control cables into their
respective terminals (see e.g. ).
• For information on the installation of larger units, please contact
your local distributor.
• For Information on cable installation according to UL
regulations see Chapter 6.1.6.
• Ensure that the control cable wires do not come in contact with the
electronic components of the unit.
• If an external brake resistor (option) is used, connect its cable to
the appropriate terminal.
• Check the connection of the ground cable to the motor and the
frequency drive terminals marked with .
• Connect the separate shield of the power cable to the ground
terminals of the frequency drive, motor and the supply centre.
• Attach the cable protection plate with the screws.
• Ensure that the control cables or the cables of the unit are not
trapped between the frame and the protection plate.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com
6