NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

132 Description of Parameters Honeywell
165 AI1 joystick offset 6 (2.2.2.11)
Define the frequency zero point as follows: With this parameter on display, place the
potentiometer at the assumed zero point and press Enter on the keypad. Note: This will
not, however, change the reference scaling.
Press Reset button to change the parameter value back to 0,00%.
166 AI2 joystick offset 6 (2.2.3.11)
See par. ID165.
169 Fieldbus input data 4 (FBFixedControlWord, bit 6) 6 (2.3.3.27)
170 Fieldbus input data 5 (FBFixedControlWord, bit 7) 6 (2.3.3.28)
The data from the fieldbus (FBFixedControlWord) can be led to the digital outputs of the
frequency drive.
179 Scaling of motoring power limit 6 (2.2.6.7)
The motoring power limit is equal to ID1289 if value 'Not used' is selected. If any of the
inputs is selected the motoring power limit is scaled between zero and parameter
ID1289. This parameter is available for NXP drives only.
0 = Not used
1 = AI1
2 = AI2
3 = AI3
4 = AI4
5 = FB Limit Scaling ID46 (monitoring value)
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com