NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Honeywell Description of Parameters 187
728 4mA reference fault: preset frequency reference 234567 (2.7.2)
If the value of parameter ID700 is set to 3 and the 4mA fault occurs then the frequency
reference to the motor is the value of this parameter.
730 Input phase supervision 234567 (2.7.4)
0 = No response
1 = Warning
2 = Fault, stop mode after fault according to ID506
3 = Fault, stop mode after fault always by coasting
The input phase supervision ensures that the input phases of the frequency drive have
an approximately equal current.
731 Automatic restart 1 (2.20)
The Automatic restart is taken into use with this parameter.
0 = Disabled
1 = Enabled
The function resets the following faults (max. three times) (see the product's user's
manual:
• Overcurrent (F1)
• Overvoltage (F2)
• Undervoltage (F9)
• Frequency drive overtemperature (F14)
• Motor overtemperature (F16)
• Reference fault (F50)
732 Response to thermistor fault 234567 (2.7.21)
0 = No response
1 = Warning
2 = Fault, stop mode after fault according to ID506
3 = Fault, stop mode after fault always by coasting
Setting the parameter to 0 will deactivate the protection.
733 Response to fieldbus fault 234567 (2.7.22)
Set here the response mode for the fieldbus fault if a fieldbus board is used. For more
information, see the respective Fieldbus Board Manual.
See parameter ID732.
734 Response to slot fault 234567 (2.7.23)
Set here the response mode for a board slot fault due to missing or broken board.
See parameter ID732.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com