NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Honeywell Description of Parameters 205
1316 Brake fault response 6 (2.7.28)
Defines the action when a brake fault is detected.
1317 Brake fault delays 6 (2.7.29)
The delay before the brake fault is activated. Used when there is mechanical delay in the
brake.
1324 Master/Follower selection 6 (2.11.1)
Select Master/Follower mode. When the value Follower is selected the Run Request
command is monitored from Master. All other references are selectable by parameters.
0 = Single Drive
1 = Master
2 = Follower
3 = Current master
4 = Current follower
1352 SystemBus fault delay 6 (2.7.31)
Defines the delays for the fault generation when heartbeat is missing.
1355 to
1369 Flux 10…150% 6 (2.6.29.1 – 2.6.29.15)
Motor voltage corresponding to 10%….150% of flux as a percentage of nominal flux
voltage.
1382 Speed control output limit 6 (2.10.15)
The maximum torque limit for the speed controller output as a percentage of the motor
nominal torque.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com