NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

7
96(110) Control keypad
Default page in the operating menu (P6.6.2)
To set the location (page) in the Operating menu (in special applications only) to which the display
automatically moves as the set Timeout time (see below) has expired or as the power is switched on to the
keypad. See setting of Default page above.
Timeout time (P6.6.3)
The Timeout time setting defines the time after which the keypad display returns to the Default page
(P6.6.1) see above.
Move to the Edit menu by pressing the right arrow menu button. Set the timeout time required and confirm
the change with the Enter button. Return to the previous step anytime by pushing the left arrow menu
button.
READY
READY
READY
I/Oterm
I/Oterm
I/Oterm
P6.6.3 P6.6.3 P6.6.3
Timeout time Timeout time Timeout time
90 s
90 s.
60 s.
Figure 7-20. Timeout time setting
Note: If the Default page value is 0 the Timeout time setting has no effect.
enter
CONFIRM CHANGE
CANCEL
Contrast adjustment (P6.6.4)
In case the display is unclear adjust the contrast through the same procedure as that for the
timeout time setting (see above).
Backlight time (P6.6.5)
Giving a value for the Backlight time, can determine how long the backlight stays on before going
out. Select here any time between 1 and 65535 minutes or 'Forever'. For the value setting
procedure see Timeout time (P6.6.3).
7.3.6.7 Hardware settings
NOTE: The Hardware settings submenu is protected with a password. Store the password in a
safe place!
In the Hardware settings submenu (S6.7) under the System menu it is possible to further control
some functions of the hardware in the frequency drive. The functions available in this menu are
Internal brake resistor connection, Fan control, HMI acknowledge timeout and HMI retry.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com