NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Honeywell Description of Parameters 189
850 Fieldbus reference minimum scaling 6 (2.9.1)
851 Fieldbus reference maximum scaling 6 (2.9.2)
Use these two parameters to scale the fieldbus reference signal.
Setting value limits: 0 ≤ par. ID850 ≤ ID851 ≤ ID102. If par. ID851 = 0 custom scaling is
not used and the minimum and maximum frequencies are used for scaling.
The scaling takes place as presented in Figure 8-10. See also chapter 9.7.
Note: Using this custom scaling function also affects the scaling of the actual value.
852 to
859 Fieldbus data out selections 1 to 8 6 (2.9.3 to 2.9.10)
Using these parameters, you can monitor any monitoring or parameter value from the
fieldbus. Enter the ID number of the item you wish to monitor for the value of these
parameters. See chapter 9.7.
Some typical values:
1 Output frequency 15 Digital inputs 1,2,3 statuses
2 Motor speed 16 Digital inputs 4,5,6 statuses
3 Motor current 17 Digital and relay output statuses
4 Motor torque 25 Frequency reference
5 Motor power 26 Analogue output current
6 Motor voltage 27 AI3
7 DC link voltage 28 AI4
8 Unit temperature 31 AO1 (expander board)
9 Motor temperature 32 AO2 (expander board)
13 AI1 37 Active fault 1
14
Motor current (drive independent)
AI2 45
given with one decimal point
Table 8-13.
876 to
883 Fieldbus data IN selections 1 to 8
Using these parameters, you can control any monitoring or parameter value from the
fieldbus. Enter the ID number of the item you wish to control for the value of these
parameters.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com