NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

138 Description of Parameters Honeywell
307 Analogue output function (2.16, 2.3.2, 2.3.5.2, 2.3.3.2)
This parameter selects the desired function for the analogue output signal.
See pages 9, 17, 29, 42, 56, 81 and 114 for the parameter values available in the
respective application.
308 Analogue output filter time 234567 (2.3.3, 2.3.5.3, 2.3.3.3)
Defines the filtering time of the analogue
output signal.
Setting this parameter value 0 will
deactivate filtering.
%
100%
Unfiltered signal
63%
Filtered signal
t [s]
ID308
Figure 8-13. Analogue output filtering
NX12K16
309 Analogue output inversion 234567 (2.3.4, 2.3.5.4, 2.3.3.4)
Inverts the analogue output signal:
Maximum output signal = Minimum set value
Minimum output signal = Maximum set value
Analog
output
current
20 mA
See parameter ID311 below.
12 mA
10 mA
4 mA
0 mA
0
0.5
ID311 =
200%
Max. value of signal
selected with ID307
1.0
ID311=
50%
ID311 =
100%
NX12K17
Figure 8-14. Analogue output invert
310 Analogue output minimum 234567 (2.3.5, 2.3.5.5, 2.3.3.5)
Defines the signal minimum to either 0 mA or 4 mA (living zero). Note the difference in
analogue output scaling in parameter ID311 (Figure 8-15).
0 Set minimum value to 0 mA
1 Set minimum value to 4 mA
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com